Customized KYMCO GY650 GY6125 Scooter Ignition coil component Black
Wiring: usually there are two sets of coil ignition coil, primary and secondary coils. Primary coil with a thicker wire, usually about 0.5-1 mm enameled wire wound around 200-500 turns; secondary coil with thin wire, usually about 0.1 mm enameled wire wound around 15000-25000 turns. One end of the primary coil of the vehicle low voltage power supply (+) coupled to the other end of the switching device (breaker) is coupled. One end of the secondary winding coupled with the primary coil, and the other end coupled to the high voltage output terminal of the high voltage output of the ignition coil principle reason for the second car can become the low voltage high voltage is due to the same general form of a transformer, the primary winding larger than the number of turns of the secondary coil. But the ignition coil transformers work but not the same as ordinary, ordinary transformer is continuous work, and the ignition coil is intermittent work, which according to the different engine speeds at different frequencies repeated storage and release energy. When the primary coil is powered, the current with the growth of a very strong magnetic field is generated around the iron core of the magnetic energy stored; primary coil when the switching device so that the circuit is disconnected, the rapid decay of the magnetic field of the primary coil, the secondary coil will induce a high voltage. The primary coil magnetic field disappears faster, the larger the current interrupting the current moment, the turns ratio of the two coils is larger, the higher the voltage out of the secondary coil.
Ignition coil in accordance with the magnetic circuit is divided into open and closed magnetic magnetic two. Conventional ignition coil is open magnetic, with its core of about 0.3 mm steel sheet folded, secondary and primary coil wound on a core. Closed magnetic core is used around the shape Ⅲ primary coil, outside and then around the secondary coil, the magnetic field lines from the core to form a closed magnetic circuit. Advantages of closed magnetic flux leakage ignition coil is less energy loss, small size, and therefore widely used electronic ignition system ignition coil magnetic closure.
Material: ABS, Normal Plastic, Iron, Steel,Alloy Rubber Stainless steel